ktag vs bosch edc16c39 opel/suzuki

[Mantulis]

Hello, i have troubles reading edc16c39 from opel zafira 88kw 2011, suzuki sx4 88kw, before had same problem with opel astra 1,7cdti...
is it normal that ktag(reworked) will not read this ecu? says this microprocessor is not recognized (mpc500 motorola). so what tool is needed to BDM those if ktag is no-go? xprog? bdm100? any other cheap and realible solutions?

[Raider20]

BDM100 should do it. I did a few some time ago.

[pulsar2000]

you need to read BDM mode. very easy to read,
you sure your probes on correct, and power ?
Clone k tag works fine BDM, well mine ok

BDM100 and fgtech all work ok,
im sure you must have a probe wrong, make sure all probes good contact,,,,

[Mantulis]

yes all connections checked very carefully, all was soldered like needed to be, power supply used 12v 4a not cheap that come with ktag, and this did not work on 3 ECU of this type... software trasdata, gives error "unindentified microcontroller e000020"

ktag tested and worked on edc17c46

[blazej1200]

Increase the voltage to 13.5 volts

[Mantulis]

blazej1200 you think with 13,5v "unindentified microcontroller" error will be gone? :D

[pulsar2000]

sounds like your tool.,... BDM ~~~~ no work,,,
never played upping volts. just works on 12. 12.5 V

[saeed9321]

I'm facing the same problem, how to solve it ??