Sagem UCH-N2 Opel Vivaro

[ilen]

Hello,
I need a dump for Sagem UCH N2 ... H1 V5.0
P8200156016
Opel Vivaro 2003 year ...
This is an original damp393633, but I think it's broken ?... deleted the VIN number ... (W0LF7BBB53V617478) .. maybe have other defects in the content dump...?
Any help could use me....

Thenxxx...

[electrones]

Hi firend
Maybe is damaged but size is okk and check if your car in CAN or not, if not Vin is not come written in UCH as like renault
here u are your pin F7F5B97FFCD9 EFfi detect your file is okk

Cheers

[jolidj]

what problem have on the car?

[ilen]

what problem have on the car?

immo diode blilnk, does not see the key ... but the ZED BULL key is read OK....
in ECU has no errors...

[jolidj]

maybe antenna problem on car?

[albertros]

single button key, start by resoldering key, inc pcf7946
Check with Renault clip, key recognised, key accepted.

[electrones]

immo diode blilnk, does not see the key ... but the ZED BULL key is read OK....
in ECU has no errors...

Make diag. check for DTCs and on real data check if key it is recognized or not
Try to add new key u have pin code to check if is antenna, wires fault or your old key is tired

Cheers

[ilen]

Hello,
First thanks for all the advice, thanks all friends...
.....
I took off the EEPROM and in damp entered the VIN number, then I reprogrammed the old key car is started up without a problem.... the experiment many times, I took off the clamp with akumolatora, everything was ok...

but after a few hours then came back the same problem...I put some photos here....393820 393826 393824
393828


Now I have two errors in UCH module ....
- no vehicle speed signal
-airbag malefuncion

[Bllinda]

Try .... .... DF.F9.79.F7.F5.BC_al.go2

[albertros]

"- no vehicle speed signal"
may go away if you move the car

[electrones]

Hello,
First thanks for all the advice, thanks all friends...
.....
I took off the EEPROM and in damp entered the VIN number, then I reprogrammed the old key car is started up without a problem.... the experiment many times, I took off the clamp with akumolatora, everything was ok...

but after a few hours then came back the same problem...I put some photos here....393820 393826 393824
393828


Now I have two errors in UCH module ....
- no vehicle speed signal
-airbag malefuncion

I think maybe u have conflict on UCH fault

Cheers

[electrones]

.......................