View Full Version : Peugeot 206 2005 - want to set mileage to 0
fogducker
30th September, 2016, 10:03 PM
Hey guys, I have a replacement instrument panel from a 2005 Peugeot 206 that I would like set to zero miles so the BSI can set it back to the actual mileage on my vehicle. Do any of you have a dump I can use or will it be necessary to change the dump from my panel?
I can read the dump fine using a CH341A reader but I don't think I can write a new dump back using it.
clusters
30th September, 2016, 10:05 PM
If you can't write a new dump back, what's the point of looking for one? :hmmmm2:
Post your dump and I'm sure someone will oblige.
fogducker
30th September, 2016, 10:07 PM
sorry, should have said that I'll have to get another programmer that can write back lol
fogducker
30th September, 2016, 10:09 PM
400955
Hopefully this works!
clusters
30th September, 2016, 10:21 PM
Good luck..................
fogducker
30th September, 2016, 10:26 PM
Thank you! Can I ask which programmer you'd recommend to write to the Atmel 25020?
rola1971
1st October, 2016, 09:39 AM
Thank you! Can I ask which programmer you'd recommend to write to the Atmel 25020?
upa usb,carprog,orange5.......
fogducker
7th October, 2016, 09:18 PM
Can anyone tell me what the actual mileage is in the dump I posted? If it's less than 81000 miles I'll just plug it in without writing zero to the chip.
nikz
8th October, 2016, 06:49 AM
it has more than 81000 mil, and he bad read
fogducker
9th October, 2016, 11:48 AM
Thank you. The dump is bad? Probably because of the cheap CH341A I used to read
it.
nikz
9th October, 2016, 12:02 PM
yes, dump is bad
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.