Toyota Denso 89560

[apratama316]

Hi everyone,

i get problem with Denso ECU 89560 series,

may i get information about best tool for read and write, with software for edit?


So far i try with bitBox,and got 89663-8F305 Software ID....

any help would be appreciate....

[voltechcar]

k-tag, off course orginal, clone dont read this processor

[apratama316]

@voltechcar : may i buy for ECM Titanium too?
i have plan for buy Alientech but not sure, because everytool i have, BitEdit, BitBox have not support.....very confused...
Thank You for help....

[Act Tuning]

@voltechcar : may i buy for ECM Titanium too?
i have plan for buy Alientech but not sure, because everytool i have, BitEdit, BitBox have not support.....very confused...
Thank You for help....

What not support ?? bitbox read on Ecm ?? if that what you mean you wrong, no problem to read virtua read with bitbox, and load i into ecm, done serval with ecm, in max you will need to ask driver and they replay within 2-3 hours, good support there,

[apratama316]

@Act Tuning : I have read using BitBox - VR mode, result Software ID : 89663 - 8F305, then contact BitEdit support for need that file for editing, but they tell me not have it nd cannot support for that file...
may i know best way for it?

[Act Tuning]

@Act Tuning : I have read using BitBox - VR mode, result Software ID : 89663 - 8F305, then contact BitEdit support for need that file for editing, but they tell me not have it nd cannot support for that file...
may i know best way for it?

In new gen Toyota, it virtual read, so if it have the file on the server, the bitbox will download the file, and you can load it and edit it with Ecm with no problem.
If they dont have file on server you just need to wait until they do, i did alot of new Hilux 2016 2.4 new gen all files where in server , so until now all good,
hope it help you.

[apratama316]

@Act Tuning : Thank You...

[jecdu33]

Hello
I have a daihatsu yrv with Denso 89560 , what is Ktag protocol for this ecu ?
best regards