S3000 immo off

[yeager]

hi, can anyone help me? i read eep 95160 from this ecu, but there is only 00 00 00 00 00 ... is this normal? how can i make immo off on this ecu?

[yeager]

is it possible write to it other file whit turned off immo? car is renault megne, year 2004, 1.4 petrol, 16v, 74kW ...

[Pyromaniak]

Hi, how you read? try someone device to try read. I think you have bad read.

[yeager]

i read whit upa, a hour before i read other 95160 from p206 BSI without problem ...

[Pyromaniak]

try all pads good connection... You try to read on pcb or you desolder? its no normal if eeprom its full nulls

[yeager]

i desolder it ... im surprised too ... i go and try again

[Pyromaniak]

if you have a file, post it and im try to help you

[yeager]

:-) my misstake, i try read L96150 from upper side of ecu, eep 95160 was in other side :-)
here is my dump

[Pyromaniak]

:rofl: sometime have I some mistifications to :chuncky:

Try this file, good luck :02.47-tranquillity:

[okura]

possible make virign, but you need matched UCH with card and sterring lock (or steering emulator)

[Pyromaniak]

Tady to funguje, vid okuro, to neni jak na checksum.cz :chuncky: lidi si tu vic pomahaji

[Bllinda]

English is .... ;)

[Pyromaniak]

English is .... ;)
Im sorry for that message, its for okura... I say, here ist better place, like other czech forum. :D

[yeager]

i cant reprogram lines from 600-7FF, try fill 00, FF but nothing ...

[Pyromaniak]

if you have try xprog, or any device or any eeprom.

[yeager]

you have right, BeeProg program it without problem :-)
tomorrow will try ... thx

PS: inak mas pravdu, skoda, ze to nefunguje takto aj na sk/cz forach :-)
PS: you have right, its a problem, that this not work on sk/cz forums :-)