PDA

View Full Version : Peugeot edc17c10 torque limitation.



Hamai
4th October, 2016, 04:29 PM
Hi,

I'm looking for torque limitation/torque monitoring in this ecu. Someone can help me ?
I Think, that it's 22 maps start at 0x1818F8 and last 0x184AD0. And maximum of inner engine torque at 0x18527C
I'm right ?

401637

voltechcar
4th October, 2016, 07:39 PM
for this ecu solution to monitoring TQ off not work, check your modify file

Hamai
4th October, 2016, 08:40 PM
Without modify these maps I have problem with ESP system. Engine goes to service mode.
With modify, engine working ok but i have message "Engine fault: Need repair".This message is displayed only once after reflashing ECU. And dtc code is FAFF (in BSI module)

Act Tuning
4th October, 2016, 08:46 PM
You got this wrong, something not ok with your tune, we did alot of edc17cp10 psa never seen that problem or fault, check you tune file again.

ecutuners
4th October, 2016, 09:20 PM
Yes this ecu torque monitor off no problem. Same procedure as most edc17 with torque monitoring

voltechcar
4th October, 2016, 09:21 PM
upload ori and tune file, i see

Hamai
5th October, 2016, 07:32 AM
upload ori and tune file, i see

Original is above.
Mod is attachment.
Mod is very easy. TQ limiters, relative engine torque of function monitoring, smoke, turbo, driver wish and EGR hysteresis. I don't understand where I made a mistake.
401740

mario38
5th October, 2016, 07:41 AM
Hi,

I'm looking for torque limitation/torque monitoring in this ecu. Someone can help me ?
I Think, that it's 22 maps start at 0x1818F8 and last 0x184AD0. And maximum of inner engine torque at 0x18527C
I'm right ?

401637
which dtc error is present when it is reported, the boundary issue?
You have tried to remove the DTC to try if tq error is signaled by dtc off?

Hamai
5th October, 2016, 07:53 AM
which dtc error is present when it is reported, the boundary issue?
You have tried to remove the DTC to try if tq error is signaled by dtc off?

The only error that occurs, except message on console is a faff i module BSI.

voltechcar
5th October, 2016, 08:04 AM
for you this is good tune?

sorry but this mod it's not good. 2 limiter nm its not change. You modify maps turbo its crazy, because you change turbo pressure to 180nm?

Hamai
5th October, 2016, 08:33 AM
for you this is good tune?

sorry but this mod it's not good. 2 limiter nm its not change. You modify maps turbo its crazy, because you change turbo pressure to 180nm?

Ok, thank for suggest. I have to correct it. It's my first Peugeot with edc17 ;)