PDA

View Full Version : EDC15P+ Possibly burned. Help for checking electronic components



Meyy123
6th October, 2016, 12:04 PM
Hello,

my ECU gave Errors at Galletto flasher then i tried to flash in bootmode. Possibly I made a short circuit ( But i dont know for sure ) because its completely dead now. No reaction to Bootmode with MPPS.

Does somebody have instructions to check the electronic components on the ECU ? Or maybe experience which part could be burnt and how to check ? My plan was desoldering defective parts and swap with neu.

I think the 29F400BT is fine.

Meyy123
6th October, 2016, 12:12 PM
402042

The part in the left corner above (Connections below) are getting warm when connected to mpps and power supply.

Fordprobe
6th October, 2016, 12:48 PM
forget about fixing it. Just get another one and swap eeprom!

Meyy123
6th October, 2016, 01:01 PM
Ok is it plug an play swapping the eeprom Without programming? I have exactly the same ecu but problems with adapting immo. İt would be great if its done with swapping the eeprom with the old one. Which component is the eeprom

Meyy123
6th October, 2016, 02:39 PM
I just swapped the EEPROM chips and the engine is running !!!! Thank you very much mate !! Have a nice weekend :)