2008 Ford Focus

[maaxxyy]

Hi guys i,m trying to source/identify the correct transponder to manually write the data to from the instrument cluster eprom data (1M08F). Its a carbon id63 chip and i should be able to use a TPX2 or EH2, but i cant seem to find them in the uk. I have a id63 4D 80 bit, but i think its prec-oded for obd programming. I'm also using zedbull clone with effi software. Any advice will be appreciated. Thanks

[stalonerambo]

sbb, by obd, and 10 minuts, it's done, or you can buy the transponder from chineses

[maaxxyy]

Thanks for the reply but i dont have the car with me, just the ecu's. This is why i need to manually write the key data to the chip. But struggling with which chip to use or source. Just got hold of a newer version of effi which has a 4D tool built into it when loading the dash file. But this still doesnt allow me to write the key data i have manually. Unless i use a TPX2 which i cant seem to find.

[scotlock]

Hi. Fit the dash in another car and code in the key by obd. Remove dash job done.

[matt224200]

should be an 599114 if there's an blue pop out ford emblems its 599114 or if just printed on its H72 it quick test iv done 300+ fords oh and if its and tuck /car thats having issues with ecu/computers it will take an re flash clusters/ecu computers and have 2 be matching again 2 work again my uncle would not listen 2 me with his junky ford truck and would get parts from junkyards and would get one number off and hand issues with his truck. it sat for 6 months and spent countless hours trying 2 be an parts changer.

[maaxxyy]

Thats easier said than done as i dont have another focus i could use.

[matt224200]

Thats easier said than done as i dont have another focus i could use.

ok give me the cluster / ecu serial number label pic we so get matching. that your going to need il check where i can get it here the usa and i get you some phone number get your part order and shipped to you so get this job done. il check back latter :)

[Cr4nky]

Shouldnt have any issue getting tpx2 chips, most uk suppliers have them.

Sent from my SM-G930F using Tapatalk

[gttuning]

Tpx2 3d has them in stock.

Sent from my SM-G935F using Tapatalk

[paul_12345]

well tpx2 are being sold on ebay so not looking too hard for them.

[maaxxyy]

Yes i have seen them on, but they all say they can only be programmed by ad900, i only have zedbull! If anyone can confirm they can be programmed by zedbull i will buy them.

[parapilot]

Zedbull can use / program tpx2 fine. Iv done hundreds if not thousands through the shop on zedbull.

[maaxxyy]

Thanks i'll give them a go. My zedbull is a clone with effi 2.72 software.

[Gavra]

Even if it doesn't work it cost less then cup of coffee.........try it it's cheap :)

[maaxxyy]

Right i finally got some cn2 chips, tpx2 compatible. I've manually written the key data, but one thing i'm unsure of is page 4 which wont store the edited data. Page 1,2,3 locked is fine.