reset ecu toyota avenza G key

[TM100]

Hello Friends someone to reset ecu toyota me venza 2010

[ucokseparoh]

403946

give it a try mate..

[TM100]

hi my friend your file is not good:apologetic::apologetic:

[ucokseparoh]

Does immo light steady/blinking/off ??

too bad.. i modified the file in accordance to a brand new immobox belong to Toyota Quantum. Tested on Tango,detected as virgin and asked for a key with pg1 XF (which is an indicator for a virgin dump)

there is actually another method so said by some fellows here which is to replace the value in certain line.. If you want to give it a try just tell me mate..

that's the only methods i know so far about virginizing G dump..

G'luck.

[TM100]

you can send me a picture of the line to change please freind

[ucokseparoh]

check pm mate. :)

[strikeforce2]

use x100 pro or techstream generate the seed code and request for pass code.

[daniersms]

Listen just write this file and use a G-key --- switch ign on -- wait 5s for the light to go out ----switch ign on-off 5 times and it will start if anything else is ok

[TM100]

Thank you ucokseparoh the solution you give me is good

[ucokseparoh]

Anytime mate.. and thanks for the feedback too..

Sent from my ASUS_T00F using Tapatalk

[fai3334322081]

also need pass i have same problem thanks in advance

[Chongcheeluan]

tm100 that file can use??

[Chongcheeluan]

hello daniersms..the u give is for which car which part number.. plss

[daniersms]

hello daniersms..the u give is for which car which part number.. plss

Hi friend post the dump from your immo-box for g-key and I will prepare it for you to accept a new key.It is better to use the original file because that file should be right for the vehicle you want to start