View Full Version : Ford focus 2l tdci wont rev up
ecufix
22nd October, 2016, 08:36 AM
Hi can you please check this dump for me , this car wont rev up and the only fault code is air intake sensor .Attached please find dump flash Sid803a read with Galletto v54,thanks ,regards
Babos
22nd October, 2016, 08:48 AM
Dump have dpf and dtc.
Next step found original dump(imposibol 90%) or go to update sw and then start fix all problem with engine abd again to do dpf off.
Best regards.
ecufix
22nd October, 2016, 09:24 AM
Dump have dpf and dtc.
Next step found original dump(imposibol 90%) or go to update sw and then start fix all problem with engine abd again to do dpf off.
Best regards.
Hi is this something you can do for me ?if so please ,thanks ,regards
sjsephy91
22nd October, 2016, 11:31 AM
Chech rpm in diagnostic for start...
Sent from my SM-G935F using Tapatalk
ecufix
24th October, 2016, 07:59 AM
Chech rpm in diagnostic for start...
Sent from my SM-G935F using Tapatalk
I have engine speed on diagnostics the only variable that does not change when accelerator depressed is throttle it stays on 0 but the accelerator pedal position sensor does change from 5 to 93 percent.any ideas ? thanks ,regards
ecufix
24th October, 2016, 02:20 PM
Problem solved by using Volta sensors decoding,thanks regards
bobolin4o
24th October, 2016, 03:05 PM
Problem solved by using Volta sensors decoding,thanks regards
Great program... i always use it and every time with 100% success!!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.