Renault kangu Dci 8200303623 Immo OFF

[nezocas]

Hi,

Need Immo OFF from this dump.
ECU n? 8200303623. Manufacture date 08/04/2003
Plastic side with hole made to remove AT25080

Best regards
Nezocas

[vlaki electric]

Hi,

Need Immo OFF from this dump.
ECU n? 8200303623. Manufacture date 08/04/2003
Plastic side with hole made to remove AT25080

Best regards
Nezocas
try this file,only need to put wp leg on eprom on ground,i meen rinse wp pin3 and put on leg 4 ground
405776

[nezocas]

Hi,

File re-uploaded to eeprom.
Do I need to rise up the write protect pin, when I go to reisntall it inside the ECU...??? Or just solder it as it was originally.

regards

[vlaki electric]

write that file i send to you. rinse from pcb wp pin and put him on ground. pin 3 put on pin4

[nezocas]

Ok,

Done.
Will report back to you, when tested on the car.

Best Regards
Nezocas

[nezocas]

write that file i send to you. rinse from pcb wp pin and put him on ground. pin 3 put on pin4

Do I need to make some more changes to the car / wiring / or emulator of some kind..???

If not, will report tomorrow

Regards

[vlaki electric]

No need nothing. Try only that way i wrote to you

[nezocas]

No need nothing. Try only that way i wrote to you

Hi,

Installed ECU on car, removed chip from key (to test if Immo was OFF), and car doesnt start.
If the chip is inserted into the key, car will start, but is stuck at low rpm?s.

Regards

[vlaki electric]

if that then put that leg wp on her place and use this dump like virgin.

[nezocas]

Hi,

Used your virgin file, with WP on it?s place, Immo still active.

Regards