PDA

View Full Version : 1999 Acura RL key logic


mojomojo
24th October, 2016, 09:51 PM
Hello folks!

can someone please provide me with the key logic for key RED key,1 2 and 3.
I can not get my tag tool to recognize the dump but I have also tried other dumps from here and it would not recognize also.
I will be using mini tag tool Abrites(clone) my understanding is that the logic input is different from other cloners.

I normally use the EZflaz but I do not have car with me.

thanks
Klimek
24th October, 2016, 10:02 PM
key1 FF81FF14BD36BF02
key2 FF81FF14BF3BFF53
Key3 FF81FF14FF1AFF08

KEY4 FF81FF14BF36FF55
mojomojo
24th October, 2016, 10:14 PM
Thank you for the fast response...will report later on today
Klimek
24th October, 2016, 10:41 PM
sorry key3 FF81FF14BF36FF55
key4 FF81FF14FF1AFF08

​3 to 4 twisted
mojomojo
24th October, 2016, 11:22 PM
I can only I can only write eight digits under the transponder stream and 10 digits on the the transponder identifier can you help me out please where to write this information
Klimek
24th October, 2016, 11:28 PM
ready with your file generate megamos 13,,t5 generate transponders on just any copier, renumber, and put into the ignition key1, key2, key3, KEY4,......
ray-ray
25th October, 2016, 03:59 AM
Here is what he is looking for (Use brain)! Key location in dump for red key and black key. My pin calculator is also there to show you how to write on different clones. If you take a look at the calculator it will also show you eeprom read in 8 & 16 bit mode. Can you all see the key location now?
ray-ray
25th October, 2016, 05:44 PM
Did it help anybody find the location of the red & black key. Or is these tread close.
mojomojo
25th October, 2016, 06:37 PM
Did it help anybody find the location of the red & black key. Or is these tread close.

If you look at my picture I can put only 8 digits under the transponder stream and 10 digits under the transponder identifier. can you please can you please walk me through as to what information goes under the strain and what information goes under the identifier I no longer have a zedbull. Not familiar with tag tool and the key tool is not recognising my file...thanks Ray for your help
Bllinda
25th October, 2016, 07:20 PM
What is the program keys to recognize unseen? Thx


Here is what he is looking for (Use brain)! Key location in dump for red key and black key. My pin calculator is also there to show you how to write on different clones. If you take a look at the calculator it will also show you eeprom read in 8 & 16 bit mode. Can you all see the key location now?