View Full Version : BMW 3 Series 320d DDE 7 EDC17 Stock map and settings
henal
13th November, 2016, 04:35 AM
Hi,
First time i read Tricore ECU,
I need Stock/Original Settings on this ECU,
Car has been Remapped before,
car details is;
bmw 320d 2007 N47d20a
full exhaust,
ECU details is;
Bosch 0281013536
DDE 7 807 827
Infineon Tricore SAK-TC1766-192F80HL
Tool for Read FGtech v54 Chinese Clone
can pay for your time !409649
Act Tuning
13th November, 2016, 10:10 AM
Here is Stock
henal
13th November, 2016, 12:33 PM
Here is Stock
Hi Act Tuning,
is this my file modified ?,
does the eeprom file not need modifications ?
Act Tuning
13th November, 2016, 03:16 PM
I dont know didnt check, you ask for stock and you said the car was remaped, so...
henal
13th November, 2016, 07:18 PM
I dont know didnt check, you ask for stock and you said the car was remaped, so...
File fails due to OTP,
if I'm correct should this part be the same ?
programming is via boot mode,
Any solution?
Thanks in advance,
kire106ka
14th November, 2016, 12:02 AM
Try these you should write now
henal
14th November, 2016, 02:12 PM
Try these you should write now
Thanks will try today night,
i have one question, for this ecu does flash need to be same before engine start, what i mean i have fitted the ECU and using the car, can i still write your your file and engine will start ? i read somewhere the flash changes every time you start the car ??
Also Fgtech gives option for Checksum, if i want to correct it, shall i leave it as it is ?
Regards
bobolin4o
14th November, 2016, 05:00 PM
Mate, the easiest way to have original inside of the ECU is to make update with original diagnostic tool.
My advice is - go to the dealer to flash it!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.