nisan qashqai dpf off

[vasko]

i need dpf off nisan qashqai 2008 edc16cp33
0281013855
1039S21009
387004
thanks

[kinketotua]

here
--> 411810

[vasko]

car not start.check lamp and glow plug not light and fan run too

[Act Tuning]

Its sound like you dont have comunincation with the ecu, scan to confirm it, with what tool did you flash it ?

[kinketotua]

sorry friend. I check dump and is ok. I test in some cars and no problem. checksum is correct.... I dont know what your problem

[vasko]

i put ori file and car start...
I read and write with FG tech on deck,but i know when try to reprogram by obd injector codes loss...
ecu ok
file problem

[Act Tuning]

yes this is the risk you take into account with free file, i happy for you ecu ok and not damage,

[marianro2007]

i put ori file and car start...
I read and write with FG tech on deck,but i know when try to reprogram by obd injector codes loss...
ecu ok
file problem
You might losed injector codes because you didn't respected the wating time before starting the car.

[mmomotiuk]

pass in pm

[vasko]

Again not start no glow and check and fan run....ori file writed and work
I can not explain what is happening....
mysteriously but the fact...
solution please...

[mmomotiuk]

what device you are programming?

This is a test solution that works 100%

[mecafrigo]

probleme files!!! becarefull

[kinketotua]

I dont think the problem is in files..

[Act Tuning]

we still waiting for you to tell us what tool you use to flash this ecu, to understand if you have chksum problem or files problem,

[bobolin4o]

we still waiting for you to tell us what tool you use to flash this ecu...

BDM100 probably...

[vasko]

all checksumm ok friend .file i think

[vasko]

fgtech bdm mode

[bobolin4o]

From my experience... I never do checksum corrections with WinOls, etc on EDC16.
Galletto make the checksum just PERFECT!

[pulsar2000]

Think lose inj codes, using OBD Fgtech, unless you back up.
INJ Codes eeprom area ? correct ?
I had a similar issue year or 2 ago Nissan Patrol i think, lose inj codes and no start,
in the end used Consult recode and all was ok using ORIG file,
Then we use BDM to write mod and all was ok,
maybe same if you lose inj codes no start (YES NO CODES=NO START)
altho we had no fan running, just no start and DTC

what trying to say is , FGTECH will lose inj codes over OBD ! even when says supported,
use renault inj code, read,
write your mod, then use ren inj part to write codes back,
if not BDM !

[vasko]

kinketotua your file updated works perfect...i write with kess and car start and no fault codes .
Problem fg tech...1st time i have this problem...I Apologise ....
Thanks again ....

[kinketotua]

perfect. no problem. The important thing is that you solved

[ANOUARBH]

Hello,
So we can say when we use kess v2 the car will start without edit the injector codes?
Thx

[ANOUARBH]

Hello,
I have the same problem, quashquai in my workshop, i need MP for the folder SVP.
thanks in advance