Change cd30 in meriva with op com

[honingkoning]

Guy's i need to change radio in a meriva,
I read eep with Martech and unregistered with martech.
But car is stil beeping and message safe is active.
Could someone explain me what correct procedure is to unregister old radio and register new radio.

I already tried to go into immo (with old radio installed).
Deactivate anti theft fit new radio and active anthi theft.

But it does not work either.

[plasma533]

Correct procedure should have been to go into EHU and select deactivate theft protection. This would have unpaired both the radio and display. You can confirm they are deactivated in data blocks (opcom) and it will say Delivery State.

Then you would have installed the new radio, checked the MID SPEED canbus to make sure it matches the old radio / display and then program Theft Protection.

Now as to where you currently are? Does the radio beep every 10 seconds or say radio safe permantly on the display?

[honingkoning]

Correct procedure should have been to go into EHU and select deactivate theft protection. This would have unpaired both the radio and display. You can confirm they are deactivated in data blocks (opcom) and it will say Delivery State.

Then you would have installed the new radio, checked the MID SPEED canbus to make sure it matches the old radio / display and then program Theft Protection.

Now as to where you currently are? Does the radio beep every 10 seconds or say radio safe permantly on the display?

It Beeps every 10 sec

[shooting]

It Beeps every 10 sec

This might help.. you'll need either OPCOM or TECH2 to pair the new radio


CD30 Error Messages
===================
If you see "DISPLAY SAFE" permanently shown after 10 seconds,
this means that the Display has not been correctly programmed to the vehicle.
If you see "DISPLAY SAFE" flashing every 10 seconds, this means that the Display
is currently in Delivery Mode, and is now ready to be programmed to the vehicle
with a OBDII programmer.
If you see "RADIO SAFE" permanently shown after 10 seconds,
this means that the Radio has not been correctly programmed to the vehicle.
If you see "RADIO SAFE" and a beep every 10 seconds, this means that the Radio
is currently in Delivery Mode, and is now ready to be programmed to the vehicle
with a OBDII programmer.