View Full Version : Opel Astra delco HC11F1 read problem with X-Prog
JFR-Tuning
12th December, 2016, 09:31 PM
General question for make immo off in 68Hc11F1 Opel Delco blue and grey CONECTOR
Car astra 99
i can read the MCU WITH X-prog but only few lines to x0200
is this enough?
In Uuprog u can read Full lengh ?.. but in X-prog only some parts
i check some immobiles off they are some bits in this first part but a lot line in the rest.
so car after prog car starts short then never and immo flash
please any help for it
doctore
12th December, 2016, 09:54 PM
do you tried with the new transponder PCF7935
or do imoo off
write all FF in hc11f1 and disconnect immo box not tested
JFR-Tuning
13th December, 2016, 07:57 AM
No no new transponder. It is a low cost Projekt the immo box or cable DEFEKT .. I think
THNX M8 for you tip
but I whant also know if you need only Eeprom from Hc11F1 for immo of or full range
and
will know how I can read the other space with X-prog because if you joice more addresses it say wrong sice
doctore
13th December, 2016, 11:01 AM
i read on forum immo off is in eprom 68Hc11F1 or maybi a wrong = and Are you moved MCU and bad reading with xprog
JFR-Tuning
13th December, 2016, 04:06 PM
Is solved for all with blue grey delco new on astra G 99
read very simply without lift any legs of hc11F1
only Eeprom part is enough
bridge the gnd modA modB of the Mcu to ground
rest like the Manuel of Xprog old with 12000000 Hz OSZE read and Write very Fine
all Bits to FF
AND DOSCONECT THE IMMO BOX . CAR START AND RUN
only DTC lamp flashing
doctore
13th December, 2016, 04:07 PM
remove lapm manual cutting:dago:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.