View Full Version : MPPS 13.02 problem
shooting
15th December, 2016, 12:35 PM
Hi, I just installed a tool with 13.02 and after installing software I get this message
any ideas????
wbr
marprog
15th December, 2016, 12:59 PM
Driver must be installed and cable plugged to computer :)
shooting
15th December, 2016, 01:10 PM
Driver must be installed and cable plugged to computer :)
It is, and driver is correctly installed
wbr
dragon100
15th December, 2016, 01:15 PM
Push button start and it is load if I good remember ?
shooting
15th December, 2016, 01:16 PM
Push button start and it is load if I good remember ?
Please read whole thread, there is NO start button because the software doesn't start
tarabostesul
15th December, 2016, 01:30 PM
Run as administrator
Trimis de pe al meu SM-G900F
shooting
15th December, 2016, 01:36 PM
Run as administrator
Trimis de pe al meu SM-G900F
PERFECT!!!! Works :D
Thank you sooooo much... :D :D :D
wbr
dragon100
15th December, 2016, 01:41 PM
Be careful when you write flash with ME7.5 ME7.1 and EDC16.
OVERSPEED
15th December, 2016, 01:49 PM
Indeed, ME7.5 with 29F400 don?t work... it start asking for cicle ignition and no go... Have to recover with old 1260
Those with 29F800 and tiptronic didn?t work either
shooting
15th December, 2016, 04:19 PM
New Problem,
I'm using this MPPS to read a Laguna1 Phase2 ECU "Sirius32", there is no option for this in MPPS software,
can I use Twingo "Sirius32" setting to read this ECU or is there a known problem?
wbr
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.