Polo (Vivo) Crypto 93C86 Dash Programming Failure Help

[ruwi]

Hi,

I have an issue with programming Polo (Vivo from South Africa) that has a crypto dash. I can extract the correct pin code using Orange 5 but can't program it with Tango as the file is 'Unknown'. I have attempted programming with SuperVAG, SBB, Autel DS708 all of which are capable of programming these keys on a non-crypto dash. All the machines when programming it accepts the pin code and the light stays solid, thereafter the machine disconnects or programming fails.

Part No. 6QS920803

What I wanted to know, is there a way of programming these on bench or can I be assisted somehow to complete this job?

I have attached the dump below.

415646

Thanks!

[doctore]

tray with vcds if you have

[rola1971]

turn ignition on wait 30min and try again.one time i have to same problem

[paczus]

I think that vcds also will not do. You have to use VAS. The delay time is right?

[bonecrusher]

vcds does this no issues

[daniersms]

Yes VCDS can do this Vivo only sometimes you have to wait a little for the immo to communicate with the ecu and it when it shows new key it will be ok and accept the new key.I use VCDS original all the time and it works

[rtbdiagnostic]

Yes VCDS can do this Vivo only sometimes you have to wait a little for the immo to communicate with the ecu and it when it shows new key it will be ok and accept the new key.I use VCDS original all the time and it works
would vcds lite also work ....:driver:

[daniersms]

That I dont know