PDA

View Full Version : Marelli IAW 6LPC.105 Cloning Peugeot 207 1.4i



Morette
17th December, 2016, 06:32 PM
I have someone with a possible faulty ECU who wants it to be cloned.

What needs to be changed in these? I have a boot read of the 512kb ST10F280 memory, and I can see another chip which looks like an eeprom marked ST 2904 EZ639

Is it enough to write the flash, or maybe transfer the ST chip too?

If anyone wants the read, this is the boot read from the target ECU (not the SW I will be using, just for help if you need the original file)416139

HW 16.784.004 9654596080
SW 16.807.064 9663380880

Act Tuning
17th December, 2016, 06:49 PM
just flash st to second hand and car will start.

Morette
19th December, 2016, 09:15 PM
Thanks for your advice, but I have another request now!

The other ECU is too far damaged, boot mode or direct connections to the ST10 with xprog will not read the file. Water did reach about half of the ST10, and reflowing the BGA hasn't helped either.

Is it possible to virginise the readout in the first post?

Thanks!

peko
12th March, 2019, 12:02 PM
hi friend

have you good way to remove PCB from this ecu ?
pin boot mod under PCB ... so must remove pcb from ecu, it seem very dangeurous ...