2010 FORD F150 AL34-14B321-FA INFINEON XC2361A 56 NEED CLEAR

[djeuroalex]

Hello, i need help clearing this file i tried but still have crash data sored full.

i tried lines 4a30, 4a60, 4a70 thats not enought

please help od advice. Thank you!!

two files attached
417287

[janushaan]

you cleared too much just write this files,, clear the codes should be good

417372

[djeuroalex]

i tried your file but still have code. B1193 crash event storage full and locked.

[janushaan]

did you clear the codes,,

[djeuroalex]

yes crash data also stored in lines 510 throu 5170

i tried second attempt now crash is gone but i have code u0300 internal error when i test dtcs on table. I tried flashing original file back eprom, flash0, flash1
but same code stays internal error. u0300, is it normal on bench when everything disconnected. or did i just kill this module?

i used xprog 5.5.1 and 5.55 lifted pins 60 and 62

[janushaan]

most likely module is no good,, i usually use carprog dont even need to open the module,, 4 wires read and write,, or obd with A1 cable

[djeuroalex]

510 throu 5170 also stores crash. Module installed codes cleared. and u3000 went away. occupant needed zero calibration. did it with snapon. overything ok.

Thanks janushaan (http://www.digital-kaos.co.uk/forums/member.php/179736-janushaan) and Auto80 !

[janushaan]

nice,,, thahx know it for next time,, will double check it