PDA

View Full Version : CLONING JETTA 2,0 TSI MED17.5.2 Tprot10



OVERSPEED
23rd December, 2016, 07:01 PM
Guys, if I only copy EEPROM from old ECU to new will work ? or the OTP part in flash will avoid it to work ?

voltechcar
23rd December, 2016, 07:23 PM
not work any copy you do

OVERSPEED
23rd December, 2016, 07:39 PM
OK

This ECU bricked with Kess (boot) but dont?had the eeprom, only flash, now I managed to read EEPROM and Flash with other tool...

Can someone make it Work again ?

there is files inside now (engine don?t start)

morgano
23rd December, 2016, 08:53 PM
Seems to me your readed files are OK, do you have diagnose on OBD? can see any DTC?

OVERSPEED
23rd December, 2016, 09:59 PM
No comunications with OBD...

Overtune
24th December, 2016, 12:14 PM
Only solution is immo off

voltechcar
24th December, 2016, 12:23 PM
not only, I do this job but I have must ori and new ecu

OVERSPEED
24th December, 2016, 05:32 PM
I heard immo off on these ecu make fans allways on and EPC On too... is it true?

morgano
24th December, 2016, 08:29 PM
If you have new ecu post here dumps and we will see ;)

OVERSPEED
26th December, 2016, 01:00 AM
can't be done on this I had bricked?

I post files yesterday

morgano
26th December, 2016, 09:10 AM
Can be, but i think ecu is dead sonehow because files seem good. Unless someone have uploaded other car's files to that ecu and that's why engine no start.

OVERSPEED
26th December, 2016, 12:56 PM
no, I boot with kess, make a stg2 start writing and stop at 99%.

after that kess couldn't write flash but could read the clone file (corrupt ), that's all in a old topic mine.
fgv54 can't read password, new genius could write original file in bench (no boot), mpps could make in boot and I was able to read eeprom and flash.

jnoroeste
26th December, 2016, 01:30 PM
Hi M8,
Use ktag and make full backup, i will repair your dump.
Regards.

morgano
27th December, 2016, 01:24 AM
Files look good to me. all checksums ok. and your file differs from same original other car just after 0x17f00 the next 0xff bytes block. Which i guess are personal keys for your ecu.

So i would review the ecu for any little solder ball or joint that can be on pcb as result of the bootmode. Or damage on opening process.