0281019817 Berlingo DPF off

[Valrod]

Please help for DPF off Berlingo 1.6Hdi EDC17C10 0281019817
Code Fault
P1435 Additive pump Fault CAN
P1434 Additive pump
P2297 Lambda Fault

Thanks
417415

[cpe87]

you only need lexia for that, restore the additive pump and this found good

[Valrod]

I think it is best to eliminate the problem forever. Can you do file?

[kinketotua]

Here
--> 417479

[Valrod]

Now, The car has no power and causes Fault
U2000 Chain cinematic Bus
Wake up signal.

Any idea?
Thanks

[mario38]

Now, The car has no power and causes Fault
U2000 Chain cinematic Bus
Wake up signal.

Any idea?
Thanks

You have disconnected the pump additive, lambda sensor and differential pressure?
how the file you wrote?
if you read the file correct?

[Valrod]

You have disconnected the pump additive, lambda sensor and differential pressure?
how the file you wrote?
if you read the file correct?
Yes sensors, pump and lambda are disconect. File is correct, read FGtech Galleto in BDM mode.

[phl0at]

I have the same problem with a Berlingo 2014 1.6HDI. Made a FAP OFF file and reset the FAP filter. Even programmed the BSI module without additive and FAP and still Limp mode. Any suggestions?

[Valrod]

You have disconnected the pump additive, lambda sensor and differential pressure?
how the file you wrote?
if you read the file correct?
Yes sensors, pump and lambda are disconect. File is correct, read FGtech Galleto in BDM mode.

[Act Tuning]

No need program bsi or disconnect nothing, there is solution for this via flash only, when P1434 come, need to remove 3 area not just dtc, and delete from ecu anther area for the addtive system,

[phl0at]

And where are these areas?

[Act Tuning]

you need to find out by your self, as i did for 3 days of work.

[phl0at]

Ah ok. Found it with the help of EDC17C10 Damos. ECU not searching for Additive Pump anymore and no limp.

[Act Tuning]

very good you pro