2012 Toyota Highlander how to program remote manually

[lwood]

hello masters,..
i been trying to manually program remote for the past hour..with no success.. i been following these instructions. could someone help with some info ?
1. Start with the key out of the ignition, drivers door is open all others closed and
drivers door is unlocked.
2. Perform these steps within 5 seconds.
A. Insert the key into the ignition(Do NOT Turn) Pull key out.
B. Insert the key into the ignition(Do NOT Turn) Pull key out.
3. Perform these steps within 40 seconds.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Insert the key into the ignition(Do NOT Turn) Pull key out.
4. Perform these steps within 40 seconds.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Insert the key into ignition and leave it in ignition.
D. Close the drivers door.
E. Turn the ignition to ON (Do NOT Start) then back to OFF.
F. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should lock then unlock automatically
indicating successful entry into programming mode.
Return to step 1 if the locks do not cycle at this point.
6. Perform these steps within 40 seconds.
A. Press the lock and unlock buttons on the remtoe simutaneously for 1.5 seconds.
B. Immediately after letting go of the lock and unlock buttons,
Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door
locks should lock and then unlock once indicating successful programming. If
the door locks cycle twice, repeat steps A and B in step 6 as the remote was
not accepted.
C. Repeat steps A and B in step 6 for each new remote.
7. Open drivers door.

[ucokseparoh]

All the previous steps is similar to mine unless.. :

E. Turn ignition ON then back to LOCK (not OFF/ACC.. at least here) **do it twice if first attempt failed.
***car is responding***

F. In 40 seconds (i did it 15sec after the car is responding)
a. Press Lock & Unlock simultaneously,about 5sec
b. Press Lock

G'luck.. all the best mate.

PS : this procedure is for Fortuner 2012 i just did about a week ago. But in my case,it's an RKE,not a separate remote.

[camelgd]

Make sure your battery is up full charge, and maybe even use jump box. Had a program fail on Lexus Rx330 and found out battery was low (11.0 volts), used jump box and it programmed right off. Mine was RKE also.

[ray-ray]

What I have notice is that if a Toyota has oem remote and there is no obd2 communication with the remote section. You can use the manual way to program as shown above. Same goes vise versa if there is obd2 communication then most likely there is no manual way to perform the remote section

[autochei]

i think it s only obd procedure
this joob i make d with zefull have function for remote programing