View Full Version : 307 cruse control Connection
byati
15th January, 2017, 07:25 PM
2005 Peugeot 307 petrol 1.6 vehicle cruise control kit. Brake transmitter is 4 pin but 2 pin to BSI is empty. I could not find any connection to BSI. There are PP200 devices.
I expect your help in this regard
Geza
16th January, 2017, 07:59 AM
you have 4 wires in brake switch or 2?
if you have 4 is enaugh to install CC switch and config in BSI and ECU.
if you have 2 wires, you will need a relay to change polarity (to have 12v when pedal released and cut 12v when pressed) and a wire to ECU.
if you need location where u need to put the wire in ecu, send me the chassis number!
byati
18th February, 2017, 08:11 PM
[QUOTE = Geza; 2932977] you have 4 wires in brake switch or 2?
if you have 4 is enaugh to install CC switch and config in BSI and ECU.
if you have 2 wires, you will need a relay to change polarity (to have 12v when pedal released and cut 12v when pressed) and a wire to ECU.
if you need location where u need to put the wire in ecu, send me the chassis number![/ QUOTE]
Chassis no: VF33CNFU.K83655649
Brake sensor 4-pin but two wires connected. Can you send me the ECU connection with the relay, my friend. I guess there is no connection for BSI. Will the connection for the engine ECU?
Lexia 3 (PP2000) available
byati
12th March, 2017, 07:30 PM
ECU pin for brake shunt cable?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.