PDA

View Full Version : Kess v2 clone problems



Tell1
28th January, 2017, 07:34 PM
Hi guess im another member who needs help, im just starting tuning my own cars using kess v2 clone, k-suite andhardware version 4.036 and kess 2.15. My dilemma, i have kia sedona/carnival 2, 2.9 engine year 2008, using obd2 connector (as stated in help menu). If i use carnival 2 in drop down menu it states mode obd2, FAM 265, CHK is ticked but RD is unticked (i assume is "read". So if i go proceed.. kess 2 will get ecu info but no read capability? So i can get info but cannot proceed to read ecu file? If i use sedona 2 it shows fam and rd as ticked (assume its usable) i go to get ecu info(1st step)kess comunicates with ecu, looks like its downloading but then shows WAKE UP ERROR? I read that wake up error could be im reading wrong ecu family, but using sedona 2 in drop down list with both fam and rd as ticked and this is my car, one would think it should be ok. Help page on k suite states use obd2 and possibly thin blue wire where 12volts needed.. have tried with and without added 12volt wire.. stumped so all help graciously accepted.