PDA

View Full Version : Kess v2 clone problems



Tell1
28th January, 2017, 07:46 PM
424629Hi guess im another member who needs help, im just s424630424631tarting tuning my own cars using kess v2 clone, k-suite andhardware version 4.036 and kess 2.15. My dilemma, i have kia sedona/carnival 2, 2.9 engine year 2008, using obd2 connector (as stated in help menu). If i use carnival 2 in drop down menu it states mode obd2, FAM 265, CHK is ticked but RD is unticked (i assume is "read". So if i go proceed.. kess 2 will get ecu info but no read capability? So i can get info but cannot proceed to read ecu file? If i use sedona 2 it shows fam and rd as ticked (assume its usable) i go to get ecu info(1st step)kess comunicates with ecu, looks like its downloading but then shows WAKE UP ERROR? I read that wake up error could be im reading wrong ecu family, but using sedona 2 in drop down list with both fam and rd as ticked and this is my car, one would think it should be ok. Help page on k suite states use obd2 and possibly thin blue wire where 12volts needed.. have tried with and without added 12volt wire.. stumped so all help graciously accepted.

gazvts
28th January, 2017, 08:18 PM
maybe your ecu model/type changed after 2004 if you look carnival I , see same as sedona II DCM & yours ecu DCM 3.2 different protocol maybe write only ?

Tell1
15th February, 2017, 10:13 AM
When kess connected it reads ecu details so i dont get to choose. Even in kess says use obd2 cable..possibly need thin blue wire for extra 12v feed... ~~~~na 2=wake up error? Not sure what that is...select carnival 2 =gets ecu info but.... menu has read box unticked but write ticked...anyone know what other hardware will read/write? Galletta 4 apparently does not.

andrewsh
15th February, 2017, 11:31 AM
here stock file for your car - but Kess clone maybe not write this file. I read it by k-tag

428780

morgano
15th February, 2017, 11:55 AM
oppps repeated :)

Tell1
4th March, 2017, 04:53 PM
Thanks for file..is it file for 185bhp sedona 2008 crdi auto trans? Ordered new kess v2 will try to read file again nxt week if not i now have a file to remapped.

panasonic1
3rd April, 2017, 08:28 PM
What happened did you read through obd2

Изпратено от моят SM-J510FN с помощта на Tapatalk

Tell1
7th June, 2018, 11:29 AM
Hi, feb last year you sent me a stock file for my Sedona, you read it by k tag, I got k tag but need help with pin out, is there somewhere you can direct me to for instructions? Thanks