View Full Version : Power on LCD Speedometer 2014 Land Rover Freelander FH5210849EB
tadeo
1st February, 2017, 10:04 PM
Hi can anyone help me to power on LCD if is posasible on bench
I have some pinout
But so far I've archived after give power RPM and Speed needles move and immo light is on LCD Off 425488425489425490
425493
Regards Chris
Sent from my SM-G935F using Tapatalk
tadeo
2nd February, 2017, 08:29 PM
Anyone can help ?
Regards
Sent from my SM-G935F using Tapatalk
neospeedo
2nd February, 2017, 08:42 PM
ive tried to fire up Evoque on bench and they need CAN wake up signal
tadeo
2nd February, 2017, 08:46 PM
Do you how direction with pin Weare and how to do that Thanks
Sent from my SM-G935F using Tapatalk
neospeedo
2nd February, 2017, 08:56 PM
CAN (Controller Area Network) uses a bus signal which is a specialized internal communications network that interconnects components inside a vehicle. You would need a device that can record or log CAN traffic. Then find the exact packets pertaining to cluster functions and play it back into the cluster. Now dont ask me if it works, I haven't gotten that far. My point is that it is not as simple as a positive or ground signal.
tadeo
2nd February, 2017, 09:03 PM
Ok thanks I have can controller with i can send signal but I'm missing can bus chanel and 8bit code
To wake up dash
Thank you for your help
Sent from my SM-G935F using Tapatalk
shazlee
11th September, 2020, 09:51 AM
HI any luck with can BUS awake up signal? Is it on MS-CAN or HS-CAN? Looking for CAN BUS message and Message ID
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.