Mazda 323 lost all keys

[fadhle]

Hello guys,
I have mazda 323 model 2002 all keys are lost,the customer buy 8C key for it,
I open Ecu and read eeprom 93c56, can any one help me to get the code and the key programming steps to enter the code digit after digit, thanks in advance.

[lion0304]

Hello guys,
I have mazda 323 model 2002 all keys are lost,the customer buy 8C key for it,
I open Ecu and read eeprom 93c56, can any one help me to get the code and the key programming steps to enter the code digit after digit, thanks in advance.

Your pin: 42 56 56 88

[rokibar]

Pin code = 42565688
First cut the key and put a 8C transponder in it.
Note:With this procedure minimum 2 keys can be programmed.
1- Give ignition on and off repeatedly 6 times with 1 second delay. After 6th cycle leave the ignition off.
2- Pats(immobiliser) light on the dashboard will blink fast for 5 minutes.Wait for 5 minutes.
3- Pats(immobiliser) light will start blinking slowly, now the system is ready for entering pin code manually.
4- When the pats(immobiliser) light is off, turn ignition on, each blink is counted as 1.
As in the sample pincode, for the first digit of the pin code, wait for 2 blinks and turn ignition off.
When the ignition is off after pats(immobiliser) light goes on and off turn ignition on, when the ignition is on, pats(immobiliser) light should blink 8 times(second digit of the pin code) after the 8th blink, when the immo light is off, turn ignition off.
When the ignition is off after pats(immobiliser) light goes on and off turn ignition on, when the ignition is on, pats(immobiliser) light should blink 7 times(third digit of the pin code) after the 7th blink, when the immo light is off, turn ignition off.
When the ignition is off, after the pats(immobiliser) light is on and off, turn ignition on, after entering all 8 digits of the pin code, pats(immobiliser) light should stay on solid, when the pats light is on solid turn ignition on, now the pats(immobiliser) light should go off, now turn ignition off and remove the key from ignition.
Put the second key to the ignition and give ignition on with this key, wait for pats(immobiliser) light to go off, after the light is off turn ignition off and wait for 30 seconds.
Both keys are ready programmed to start the vehicle.
NOTE = While entering the pin code manually, when ignition is on, each blink is counted as 1.

[fadhle]

Many thank friends for fast and helpful posts.

[fadhle]

1- Give ignition on and off repeatedly 6 times with 1 second delay. After 6th cycle leave the ignition off.
2- Pats(immobiliser) light on the dashboard will blink fast for 5 minutes.Wait for 5 minutes.
3- Pats(immobiliser) light will start blinking slowly, now the system is ready for entering pin code manually.

Thank you friend ok when the ignition on, the pats light is on but when Ignition off the pats is off, how to see after 5 minutes the pats light will start blinking slowly(system ready to entering pin code manually).
also i note that when ignition on the pats light still solid for about 5 seconds then off after that blinking normally.

[mohamed faid]

Pls can u send me this dump