spc560 verify error xprog

[sorgun]

spc560 verify error xprog 5.55 read not work help please

[navatar]

I have the same problem unfortunately, still looking for a solution...

[kostrz3]

check read cable com (rs232) and plug power 12v xprog

[dariobmw]

If you want to read and write spc with a low budget programmer look at the segger jtag on ebay and you will be
happy with that interface ( little bit confusing software interface but nice working ) you kan read and write without
errors and problem that kind of processor , i was in trouble with xprog and at the end downgraded and working good
for now only with older software

REGARDS

[repairmymodule]

The verify errors in xprog is the software. I've noticed on a fresh install I can open the program and have no trouble programming the first 2 or 3, after that I get Verify errors

[alaaengineer]

the solution that worked fine and tested for all my friends
465823

[castin]

when use xprog im off internet connection.

[kostrz3]

I have the same problem unfortunately, still looking for a solution...



use cable com (rs232) and put power xprog +12v


test and report

[navatar]

Hi everyone thanks for solutions resolved it by setting the X-Prog COM port latency in device manager to 1ms instead of 16.

[navatar]

Spoke too soon still have errors going to try direct rs232 and 12v tomorrow

[navatar]

Hi don't think software is at fault as I did fresh install of Xprog 5.55 on a new computer which was never connected to internet and problems are same

[PierreTheron]

True

Is not actuall programmer crack software problem m8

[PierreTheron]

As stable with original as War of something i believe ./.........

[repairmymodule]

With me, the software is the case. 100% sure about it. I have clone xprog box 5.55

[navatar]

Hi guys thanks for all the help finally got a solution for SPC560 verify errors used a different software version mutec99 on MHH titled "XProg 5.55 no dongle". Link is attached

[Sarah1331]

Hi guys thanks for all the help finally got a solution for SPC560 verify errors used a different software version mutec99 on MHH titled "XProg 5.55 no dongle". Link is attached
Same error this works perfectly thank you

[morpee]

Hi guys thanks for all the help finally got a solution for SPC560 verify errors used a different software version mutec99 on MHH titled "XProg 5.55 no dongle". Link is attached

Can someone pls share this software again? Link is dead. Thanks