View Full Version : EZS w211 Pin out
chiptuner123
8th February, 2017, 04:17 PM
I try to connect at desk in MB EZS w211 with AVDI on CAN Lines but nothing.Is there any trick on this connection
EZS 211 545 14 08
I try In the car and connect normaly. attach the connection that I use
emanuel2010
8th February, 2017, 04:27 PM
pinouts is correct
chiptuner123
8th February, 2017, 04:38 PM
Yes but can not with CAN? where is the problem?
mercis
9th February, 2017, 06:33 AM
use 120 ohm resistor:) betwen can h and l wire
chiptuner123
9th February, 2017, 08:43 AM
EZS CAN is on 5-6 pin or 7-8
chiptuner123
10th February, 2017, 08:03 AM
I try not connect can any one help!
mercis
10th February, 2017, 11:40 AM
you have 2 can on eis
chiptuner123
10th February, 2017, 11:56 AM
YES i try on booth not connect. I use R120 ohm not connect.Did you try before?
chiptuner123
10th February, 2017, 03:34 PM
I try AVDI OBD connector direct to EZS ntohing can not connect!! Is there any other trick??
mercis
10th February, 2017, 04:18 PM
wait i check wis,must work i tested often
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.