2016 Mustang Mileage

[ascrap2003]

Ok got a friend with a 2016 Mustang whats the eeprom a 93c86? What about algo and what lines etc? Has anyone used Tachosoft OL for it?
besides trim on left and trim on right that snap in any pointers for removal?

[juancho18]

They may be:
24c16
24c32
93c86

[ascrap2003]

They may be:
24c16
24c32
93c86

Algo, dash removal procedure?

[juancho18]

Disarm with caution

http://cliparts.co/cliparts/kcK/or9/kcKor9y6i.jpg

[ascrap2003]

Disarm with caution



Wel this one was easy enough, just read eeprom with USA prog and edited it with programming, for those of you that do this, use plastic pry tools, pull passenger dash/vent trim off, clips, and trim pieces just below cluster on sides, there are screws 4-6 to be removed, then cluster trim which has a steering column trim attached to it. once u get to cluster remove to lower screws and give it a good tug, benz tools help.

[clusters]

Which eeprom? Dump? Now is your time to contribute.....

[ascrap2003]

93C86
12779 Miles
Here you go!

[ascrap2003]

Took a quick look at it is that Denso?

[juancho18]

THEN THE CALCULATION IS LIKE DENSO.
BUT I GIVE ME THE LIJERA IMPRECION THAT HAS HOURS

[jomberykaso]

Here is the script for Etsmart.

Good Luck!

[ascrap2003]

THEN THE CALCULATION IS LIKE DENSO.
BUT I GIVE ME THE LIJERA IMPRECION THAT HAS HOURS

I didnt see a hours function while it was installed in car, could the eeprom itself still have the hex? Which line?

[clusters]

No hours as far as the owners manual goes, but I'm sure the dealer could find the hours and old mileage if they looked hard enough. lol

Most likely in the ECM.

[ascrap2003]

No hours as far as the owners manual goes, but I'm sure the dealer could find the hours and old mileage if they looked hard enough. lol

Most likely in the ECM.

Yea thats usually the case options?

Abrites Commander?

Autel MS906BT

MS908?


Is J2534 Neccesary?Also i have ETsmart installed and running but trying to figure because of all the russian, how do open, read, write, save, calculate etc. is there a way to change the russian characters?

[clusters]

No idea what tool can modify them, if any.

Yes you can change all the Russian characters, all it takes is a little searching for the solution that I have seen a few times. I don't have it because I don't use ETSmart.

[XmoDDeR]

Yea thats usually the case options?

Abrites Commander?

Autel MS906BT

MS908?


Is J2534 Neccesary?Also i have ETsmart installed and running but trying to figure because of all the russian, how do open, read, write, save, calculate etc. is there a way to change the russian characters?
.......
.................................................. ..........:roflmao:

[ascrap2003]

.......
.................................................. ..........:roflmao:
Yea I know I haven't made a decision yet. If had $2500 at hand I would get the 908P. lol