CAS 3 HELP ASAP

[Everythiinng]

Hi,

I desolder the MCU FROM Cas 3 and i solder it into orange 5 adapter. When i try to read it it says RTS Wrong pin level! Am i doing something wrong? It says VVC lvl to low(2058 ) Continue!?

Anyone please help!

[Everythiinng]

Ok i finally read the MCU but it says MCU secured (BDM locked) ? Anyone any ideas?

[stan92]

i think if its interrupted it can cause this and well as voltage going up and down.
What about boot mode and security does it go past this stage when u try to read the mcu?

[Everythiinng]

I read the MCU stan, but it says MCU secure?

[kaToo]

it is secured and orange will not read it .
You should use originalor ETL rosfar or xprog or r270 and read it in circuit

[castin]

R270 - solder in circut and work wery god. Read CAS3 and cAS2 many times and without problems.