PDA

View Full Version : Help: BMW CAS3+ VIN/ISN to Eeprom/Flash


harberg
27th February, 2017, 12:51 PM
Urgent help is needed.

Can anyone write ISN 0F22CE558BBDAD704FF8F4B43465BE58, VIN WBAUX31000A206584, KM 279231 to Eeprom/Flash attached 431824?

I can write eeprom/flash back to CAS3+ but cannot change VIN/ISN. Now I have car that does not start because wrong VIN, ISN (power goes on and remote works)... and old Cas3 united is dead.

Big thanks!
ben21
27th February, 2017, 01:40 PM
Try this eeprom

Flash file cannot rework sorry.
harberg
27th February, 2017, 02:38 PM
Hi,

When reading the eeprom file with VVDI2 the VIN is correct (not ISN) but in the car VIN shows "YYYYYYYYYYYY" and still the engine not turn on.
Any ideas how to get that car running?
ben21
27th February, 2017, 04:56 PM
See this thread may help you experiment.

http://www.digital-kaos.co.uk/forums/showthread.php/461905-Online-hex-editor-for-EEPROM-editing-research-comparing
tunertool
28th February, 2017, 08:32 AM
If you send me the key + CAS... I can put the ISN and VIN into the CAS no problem
emiliogsm
28th February, 2017, 11:36 AM
change address c95h from E7 to F5 for vin checksum
dijo
1st March, 2017, 01:02 AM
Hi,

When reading the eeprom file with VVDI2 the VIN is correct (not ISN) but in the car VIN shows "YYYYYYYYYYYY" and still the engine not turn on.
Any ideas how to get that car running?

Here your file,you need to change km in dash before connect cas...cas with 0km