BALI7605
5th March, 2017, 02:55 AM
Hello,
I have aproblem which goes on for a while and i can not find a solution. This is a 2001 E200 compressor.
The job was to add a key, and i removed the EIS and removed MCU2 read it on Ak400.
I put the mcu back generated new keys with SKC but now the original key doesn't turn and the new key doesnt turn either.
Central locking works. I put ESL emulator in i can turn the key with another ESK key set, but all i can get hold of is old W208 versions and i can not match them to the ECU though i renew the ECU.
I went trough the Original ESL and checked every connection but i can not see where it went wrong.
If i connect it on the table with emulator it takes 30mA on the PSU and when i insert the key it take 80mA.
The key led is on when key inserted.
ANy ideas???
Im pulling my hair out and the customer is on my back
thx
bali
I have aproblem which goes on for a while and i can not find a solution. This is a 2001 E200 compressor.
The job was to add a key, and i removed the EIS and removed MCU2 read it on Ak400.
I put the mcu back generated new keys with SKC but now the original key doesn't turn and the new key doesnt turn either.
Central locking works. I put ESL emulator in i can turn the key with another ESK key set, but all i can get hold of is old W208 versions and i can not match them to the ECU though i renew the ECU.
I went trough the Original ESL and checked every connection but i can not see where it went wrong.
If i connect it on the table with emulator it takes 30mA on the PSU and when i insert the key it take 80mA.
The key led is on when key inserted.
ANy ideas???
Im pulling my hair out and the customer is on my back
thx
bali