Fiat G Punto clear crash

[pawel11]

Hello
I need help with clear crash from Fiat Grande punto

51775404
5wk43641
tsop st95320

[giary74]

Hi my friend, try this file and report please.
have a nice day

[pawel11]

Hello
does not work DTC B1001, B1002. SRS unit fault

[dragon100]

Compare, try and report.

[pawel11]

the same mistakes B1001, B1002. SRS unit fault

[juancho18]

DTC B1001 Fiat Auto Trouble CodeB1001 Fiat Auto Trouble Code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

Description of Fault code B1002MICU internal error (EEPROM error)
Possible failuer B1002
MICU


Diagnostic Procedure using AutoHex II Scan Tool

The low level of the ignition signal is detected at initializing Engine Control Module (ECM). (The Engine Control Module (ECM) started without input of the ignition signals.)

Test Conditions using AutoHex tester

The Engine Control Module (ECM) is initialized
The Engine Control Module (ECM) reset by the program malfunction and the Engine Control Module (ECM) internal hardware malfunction isn't executed.

Clear Fault codes Conditions

The low level of the ignition signal is detected at initializing Engine Control Module (ECM). (The Engine Control Module (ECM) started without input of the ignition signals.)

B1001 Fiat Possible Solution:Power Steering Pressure (PSP) Switch Signal Malfunction The PCM counts the number of times vehicle speed transitions from 0 to a calibratable speed. After a calibratable number of speed transitions the PCM expects that the PSP input should have changed. This DTC is set if the transition is not detected. Vehicle towed with engine running Power steering hydraulic concern was repaired but DTC was not erased PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged Check, if possible, if vehicle was towed or power steering service was performed. Observe PSP V PID while checking wires for intermittents.




Hello
does not work DTC B1001, B1002. SRS unit fault

[dragon100]

Use align proxi with elm327 and Fiat Ecu Scan ...