View Full Version : Cas3 Programmer without soldering ?
Mestern
13th April, 2017, 09:13 AM
Hello!
Is there any tools out there that can program cas3 without soldering ? And is not too damn expensive 😂
car_soft_gorj
13th April, 2017, 03:19 PM
abritus bmw !
alkaskad
13th April, 2017, 05:34 PM
I think Smok can do it OBD if you think about mileage ...
Mestern
13th April, 2017, 05:55 PM
Gonna do mileage on a bmw x5 e70 :)
raf0468
13th April, 2017, 10:40 PM
you have to be prepared to do soldering if it doesn't go obd , not all cas go obd..
i go out with intention of reading with cas3 programmer , and if it happens to go obd its a bonus.
Mestern
13th April, 2017, 11:45 PM
Ahh ok.
What tool do you think is best for obd ? :)
Just to be sure, I set cas kilometer to 0 and dash to whatever I'd like to ?
I have never done cas programming
diagtech2000
13th April, 2017, 11:55 PM
Your best just pulling it out and using rosfar, only about half go OBD and the good tools to do it arnt cheap
If you do it with tosfar you've got a save aswell
Sent from my iPhone using Tapatalk
Mestern
14th April, 2017, 01:13 AM
Worst case scenario, what can go wrong when programming cas3?
Gavra
14th April, 2017, 02:03 AM
CAS hold key data ,so you could end up buying CAS and new keys....
diagtech
14th April, 2017, 11:07 PM
Worst case scenario is expensive with cas
cokolo
15th April, 2017, 06:36 AM
I think Smok can do it OBD if you think about mileage ...
Smok can do only numer <=923xxxx
captain crackers
15th April, 2017, 09:14 AM
I have done them OBD (generally up to 2010 but also some 2011) with a digiprog 3 v4.94. I got it free in a box of cornflakes, well almost! Arthur.
Mestern
15th April, 2017, 11:21 AM
ohh, i have digiprog 3, but someone told me NOT to change kilometer with this tool :S
what can possible go wrong ? :p
have you had any problems doing kilometer with this tool ?
captain crackers
15th April, 2017, 11:48 AM
Personally, I haven't had a problem but I have only used it for the cas3+ with 9s12XDP (to the best of my knowledge). Arthur.
Mestern
15th April, 2017, 12:01 PM
ok, maybe i will give it a try then :p
but do i have to edit km in the cluster too ? or just cas3 ?
Andresolivares
15th April, 2017, 01:11 PM
DP3 elprosys o DP4
captain crackers
15th April, 2017, 01:18 PM
If you don't know what you are doing, it could become expensive if it goes wrong but yes you have to edit the km in the cluster, which means having the tool to erase the current km or use a new chip. Arthur.
Mestern
15th April, 2017, 02:03 PM
I have never done this type of car before, so I think I leave it to someone with more experience
Thanks for info and fast reply!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.