M30882FJ - reading Flash and EEPROM via E8a

[Holtek]

I have a problem with Renesas processors. I want to read and write Flash M30882FJ processor. I want to use E8a and Flash Development Toolkit 4.09. Unfortunately, but after connecting E8a to M30855FW with RST, TxD1, RxD1, GND, VCC, I get no communication. Pin /Hold to GND, pin /WRL to VCC and pin CNVss to VCC. What am I doing wrong?

https://www.renesas.com/en-eu/doc/products/tool/doc/001/r20ut0572ej0401_e8a_m16c65b.pdf

[Tereksaz]

see on pdf file and connect your E8A or rx & tx

[Holtek]

Thanks. Have you tested your solution? But should I not connect the rest of the e8A pins? I do not agree a bit. See the picture.

[simaservis1108]

Maybe boot password protected?

[Tereksaz]

it is pdf file example.pdf (http://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=443903&d=1492548592) from Renesas.eu
i can use as E8a and so simple com port and all very good read/
as example you can see on photo
http://www.azlina.ru/image/data/Dice/dice.jpg
and
http://www.azlina.ru/image/data/Dice/dice_rep.jpg

[Holtek]

Thanks Tereksaz. I managed to successfully connect the E8a to the Renesas processor. Below the documentation. 100% tested, works. Unfortunately, but my CPU is blocked by ID. It was not erased. The only solution in this case is to replace the processor.

[Tereksaz]

what the name device with
M30882FJ ????

[Holtek]

Toyota Navigation

[Tereksaz]

i dont have it firmware