A6 C6 3.0TDI How remove ABT protection/No possible any change in flash

[reewerd]

Hi.

I need any help with Audi A6 C6 3.0TDI BMK
0281 012 915

4F0 910 401S
1037 380 431

Car is ABT marked.
Any change to the file causes the engine to stop after 60 minutes.
Only re-upload full BDM allows to start the engine.


ABT has provided security in the eeprom(i think so)
and any change is move out flash after 60min.

Problem is..the car have DPF damaged and need disable them in flash but I now that is immpossible.


PLEASe Who can remove the security??

Thansk for help

[morgano]

Flash full bdm original and redo dpf off and tune.

[luca22]

If this modification is with ABT then I advise everyone not to do car there,
The program made very poorly, not touched turbo termic, poorly calibrated maps and not all worked up to it...
Flash not protected. I have their files and ABT secures all
This is not a map with ABT (I think), and the problem probably in your EPProm

In this SW nr DPF done by 4 Switches, one switch solution don't work- ECU give DTC U301, give limp mode and on dashboard blinking heating spirale

Regards
Luca

[alonedark]

yes i think is not abt mod ,somebody have original file of this , here you have one http://www.chiptuners.org/forums/viewtopic.php?f=13&t=7205&hilit=1037380431 but this is no a original too,but this file have more power that abt.

[tricore3]

your file with dpf off
with that file the car should not stop

test it please