2005 f250 dash with dsp3

[reuse]

was wondering if someone could tell me what adapter to use with dsp3 and what chip it is? i am assuming its the six solder points left hand bottom from back? thanks

[epd1221]

Mcu 912 plug .

[reuse]

yep tried that already i have a t03 and t04 thought it was the t03 didnt have any luck maybe dont have the right chip or vehicle selection?

[clusters]

Have to use the Motorola adapter and T03 I believe.

*** Disclaimer, I don't have or use USAProg or the DSP3 ***

[XmoDDeR]

ooooooboy the tool tells you

[reuse]

ohhh boy the tool does not tell you! 2006 and up on the list i need for 2005 which should be the same as 2006 states obd i have this cluster bench i have tried motorola with t03 pin but with no luck

[kubuswujo]

Here You have manual For FORD F250.

:)

454064

[morrisgauge]

Disassemble the cluster to view the actual processor, then select whichever Ford vehicle on the DSP3 that has the same processor listed. Then use the appropriate touch pin connector and so on and so forth. I find that the bigger Ford trucks contain a few different processors, but the DSP3 lists them all. Also, in this forum, prepare to be trolled for questions of this nature.

[RcCustem]

2005 F250 works obd using the program for 06 using usaprog...Ive done several that way

[epd1221]

post a pic of the board and we can help you connect the motorola adapter to board

[reuse]

454189Here is the back there is the six soderpoints lower left

[reuse]

what I want to know what processor this is and another vehicle selection that has same processor is it the hc9s12? that requires the t-04. just want to make sure because the configuration points are different than the t-03454192

[epd1221]

454193Try this hope it works found it here on forum

[reuse]

no did not work tried that configuration tried to save file get error. that configuration above is the t-04 upside down (tried didnt work) tried the t-04 in the correct position that would be with bdm on bottom right (didnt work either) only thing i can think of its a different processor?

[clusters]

in your picture, it should be

GND RESET +5V
BKGD XX XX

The large area on the board is the ground plane, you can clearly see the top left is connected to ground.

[reuse]

CLUSTERS IS CORRECT!!