PDA

View Full Version : EDC16C31 Popcorn/Hard Cut limiter



JuniorTuner
5th June, 2017, 06:34 PM
]Hello, i want to do Popcorn/Hard Cut Limiter on my e60 530D EDC16C31..
so i have read some posts and learned that, its hard to make proper popcorn on edc16 ecus... its much easier on edc15.. so i have seen some videos on youtube, same car with same ecu had popcorn.. so i liked it :D
so i want to do it myself.. what i must change? only TL maps? and tell me addresses for maps which i must edit ;)
P.S when car is in P or N gear rev limit is 3997 RPM... if i edit values of 4000RPM, i think it may have problems while driving :D i need to make hard cut limiter on both maps (while gear is in P or N and when gear is in Drive )
i think i talked too much :D sorry for that..


this is ecu, hw and sw numbers


Bosch
EDC16.A0
1037361890
1037390905


Thanks...
I hope someone will help me ;)
Best Regards 8-)

JuniorTuner
7th June, 2017, 07:25 PM
No one knows Torque limiter addresses for idle and drive? :/

ivanrojo
7th June, 2017, 07:42 PM
its quite easy, stationary torque on this car is the one which has 0 nm from 4000 rpm to the end, toque limiters use to be together on the dump, for pop corn just change iq (nm on this ecu) in a short number of rpm to 0 on TL maps..

hope it will help you.

JuniorTuner
9th June, 2017, 07:28 PM
its quite easy, stationary torque on this car is the one which has 0 nm from 4000 rpm to the end, toque limiters use to be together on the dump, for pop corn just change iq (nm on this ecu) in a short number of rpm to 0 on TL maps..

hope it will help you.

its easy to find map from 0 nm but its hard to find with rpms because in winols are not RPM s... so if u know quantity of NM at 4K RPM it would be easier.. or its same as main torque limiter?

ivanrojo
8th December, 2019, 06:16 PM
If you are not able to find rpm axle from tl maps... i think you should look for a tuner who are able to tune right your ecu.

115jtd
8th December, 2019, 06:33 PM
where file?

DiegoStud
8th December, 2019, 07:12 PM
Guessing he's had his free tune by now and left the building....

cupsi
9th December, 2019, 12:36 PM
Junior, upload ori file it will be easier for all of us to do someone for u then explain..