Read 28/29 F400 eeprom

[sdtsedat]

Hi,

Someone have any idea to read and write 28F400 or 29f400 eeprom without desolder on PCB?
I search on internet, but no found more information.

I know that some people solder cable on 44pin, but it is to much time and difficult work.
Also desolder F400 is difficult.

Is there any socket or adapter or anything to hold it on the eeprom and read/write it?
See picture in attachment.

Kind regards from Belgium

456088

[mahmoudsaq]

Using ktag

تم الإرسال من SM-T710 باستخدام Tapatalk

[sdtsedat]

With Ktag you must also desolder eeprom.
Ktag doesn't have a socket to hold it on eeprom and read/write.

Anyone some opinions or options?

[morgano]

What ecu is it?

[icezero2010]

Hi,

Someone have any idea to read and write 28F400 or 29f400 eeprom without desolder on PCB?
I search on internet, but no found more information.

I know that some people solder cable on 44pin, but it is to much time and difficult work.
Also desolder F400 is difficult.

Is there any socket or adapter or anything to hold it on the eeprom and read/write it?
See picture in attachment.

Kind regards from Belgium

456088


this is c167 processor use boot mode and good no soldiering

[lobsterosxxx]

I always desolder this type of flash using hot air gun then pop it into wellon and of you go....takes half an hour max including soldering back on board

[sdtsedat]

Picture is an example. Just for ecu EDC15vp or edc15c6 when you can't write (after bad remap)
You can always write eeprom. And i think, is there no adapter to just hold on eeprim pins and connect to eeprom programmer like batronix and read write?

Kind regards from Belgium

[daniel guerra]

Follow the instructions on this link and you'll be good.

http://blog.cardiag.co.uk/how-to-recovery-edc15-with-mpps-in-bootmode/

You can use any tool with this instructions

[catala20032004]

You can use IO Terminal with BOSCH car read writes eeprom and flash via OBD no problem.; No desoldering.