MS45.1 checksum request

[Workshop2]

I have a bench read from my original dme, and the used dme. When I directly copy all files, the engine starts but after a few min it stalls and has faults for

28B2 -- RPM limiting: reset
27A1 -- Electronic throttle controller: start check

Both DMEs do the same thing, so I'm assuming its a checksum error.

Could somebody check my ori files, or swap ews data to my used ecu files?458962

[Workshop2]

SOLVED- Cloned DME with FGTech Galletto 4 (china)- Had to READ ALL and WRITE ALL. Software froze attempting to write ext eeprom by itself. Then programmed DME with ISTA/P in expert mode.