2017 Dodge Durango Bosch 68316737AA 0285013682 T52MD323602874 Crash

[slavax]

Hello everyone,

Just finished working on this Durango today. Tried Launch and Snap-On to erase crash with no success.

EEPROM chip does not have anything on it so I read it as 95640.

Can someone Please, pLease, plEase help?? I will report results right away. Thank you!

459724

[dragon100]

Im not sure, but try read again like 95128 and post here file, ok ?

[repairmymodule]

Look closer at chip, as Dragon says, should be 95128 or 95256

[slavax]

Had to remove the chip and looked under the microscope :) It is 95128. Thank you guys!! Here is the file:

[dragon100]

Try and report, not tested, it is a fresh ...

[slavax]

Crash data error went away, however. I am getting B2207 "Occupant Restraint Controller Internal 1" Error.

[repairmymodule]

Try to 00 line 29E0 through line 3200

[slavax]

Try to 00 line 29E0 through line 3200
Did not work. Still getting Occupant Restraint Controller Internal Error. :(((

[dragon100]

Try a little different clear ...

[slavax]

Try a little different clear ...
Ok, dragon, after loading your new file I have 2 errors in total: Deployment Data Record and Occupant Restraint Controller Error.
After using your first file I had only Occupant Restraint Error but Crash Data was not present.

I might be wrong nut this can only mean that in your first file you cleared the crash data but deleted some extra stuff needed for the module to function normally.

Thank you!

[repairmymodule]

I'm just curious, I know when you started you just had crash data code, but now If you load your original file do you just have the deployment data full, crash code?

[zend]

Your original file looks not very good.
But, though, try this.

460779

[slavax]

I'm just curious, I know when you started you just had crash data code, but now If you load your original file do you just have the deployment data full, crash code?

Yes. When I load my original file I get the Crash Data message. I also disconnected two air bags to test the correctness of the original file/module. It shows the errors correctly after disconnecting air bags and I can clear them when I connect them back. Thanks!!!

[slavax]

Your original file looks not very good.
But, though, try this.

460779

Zend, thank you!!! Your file works just fine. After connecting the module SRS light is OFF and no DTCs are stored in the memory.

Problem solved. I want to thank everyone who tried to help!!! Thank you guys!

[klakier]

HI,

I have a problem with clear srs unit bosch 0285 0131. Below attached crash file. Thanks for help.


Best Regards

[fokus4]

working on the same car 2017 durango 68316737AA, could you please share the pass
my file is attached

[slavax]

Crash and Clear packaged together

[omaraied]

hi!
password please

[omaraied]

hi!
May I have the password please
Thanks

[muki25]

hi!
password please

[maxyusz]

Hi. I have same problem with Durango Srs crash. Please send me password. Regards

[maxyusz]

HI
The same story in 68355362AB 0285014040 Bosch. Car 2016 Dodge Durango. After 00 line 29E0 to 3200 still have error Ocuppant Restraint Controller Internal 1. This is crashed bin from my unit. If someone help mi with this will by thankefull.

[chemara]

Crash and Clear packaged together


Hi. Hava same troble. Can you give me the password.