Toyota corolla 2013 i want to do it on the bench

[Saman]

Hello dear dk friends i want to recalibrate toyota corolla 2013 on the bench and do not open whole instrument cluster i wan to ask is there any way to do it onback side of dash ?? Formore info i post image of dash i see five pin in a row and some other pins, if it can do there what types of programmers need? . Regards

[pongsky]

Hello dear dk friends i want to recalibrate toyota corolla 2013 on the bench and do not open whole instrument cluster i wan to ask is there any way to do it onback side of dash ?? Formore info i post image of dash i see five pin in a row and some other pins, if it can do there what types of programmers need? . Regards
Better to full out the needle it is easy mate

Sent from my SM-T705 using Tapatalk

[Saman]

I know i can do that but most time driver says fuel needle or temprature gauge needle is not in orignal place and also i think about time for me 15 minute or 20 minute is important and soldering not all time safe near MCU.

[hcip]

With correct programmer, you can do it without opening the back cover..

[Saman]

which programmer can do it can you inform me? regards

[Dr. Zoidberg]

With correct programmer, you can do it without opening the back cover..
for this pinout, do you need make denso bus with a chip ftdi?

[hcip]

which programmer can do it can you inform me? regards

StoolVDO or Clone, and I think enigma has an update on denso software..

[Saman]

thank you so much friends