View Full Version : tdm900 dash km change
gsouf
11th July, 2017, 10:18 AM
Hello everybody ,
i am trying to change the milage on my tdm900 2003 beacause my original odometer was stolen so i had to get a used one
but it seems i cant figure out how to change the hex of the eprom i attach the original dump any help is more than welcome462422
i would like to get it around 41250km
nikz
11th July, 2017, 10:25 AM
File is no good, read again as 16 bit
gsouf
11th July, 2017, 10:58 AM
i did a new reading selecting 93c56(16)
462440
i hope this helps cuurent reading is 308287km
nikz
11th July, 2017, 11:02 AM
Same dump...............
gsouf
11th July, 2017, 11:08 AM
i am using the minipro programmer to read and this the output that i get
am i doing something wrong?
nikz
11th July, 2017, 11:24 AM
1. unsolder eeprom
2. try any other programmer
gsouf
11th July, 2017, 11:37 AM
462454
thats a new reading with the g540 programmer selectec ic 93c56(16) but seems the same to me
(the ic was already disoldered)
nikz
11th July, 2017, 12:05 PM
Can you eeprom already recorded incorrectly ??
gsouf
11th July, 2017, 03:08 PM
I dont if it was written wrong but it works when i put it on the odometer
nikz
11th July, 2017, 03:15 PM
it's good
Then you need a good programmer
gsouf
12th July, 2017, 02:13 PM
hello again i managed to change the km with some numbers i found on another post and a byte swap. but i found a new problem it shows me more rpm than the actual is this a eprom code problem?
nikz
12th July, 2017, 02:15 PM
yes........................
gsouf
12th July, 2017, 02:28 PM
i dont know where to look in the .bin for this but it looks that the tachosoft numbers work in my dump do you know what to change?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.