PDA

View Full Version : Citroen Jumper 2.2HDI P0191 off please



WinWoj
19th July, 2017, 05:09 PM
Hello Folks,

EDC15C7. Please remove DTC P0191 I have to check if car lose limp mode, or not. Then I could test and check the scale of difference rail pressure on higher rpm. Please help.

WinWoj
19th July, 2017, 08:23 PM
Ok, I'll try to compare with edc15c6 from cdi engines, maybe similar way.

konq100
20th July, 2017, 06:49 AM
Check this file. DTC is disabled.

WinWoj
20th July, 2017, 11:59 AM
Same solution, many thanks. By the way, stanislav georgiev and konq100 , what is difference with DTC structure, before {C300} marker, is number, like {0001}, {0003} in EDC15C6 but in this case of EDC15C7 most of all dtc's numbers are {0007} and {0000}. What does it mean? Type of event, when DTC occurs? (Check engine lamp, limp or engine stop). If possible please explain. BR

stanislav georgiev
20th July, 2017, 12:13 PM
I think the problem with you is mechanical. Remove the regulator and cut off the Strainer Probably clogged. This is a poor fuel filter

WinWoj
20th July, 2017, 12:23 PM
Yes, I know that, but wanted to check if DTC remove engine stops. And what I see after first test - not stopping, next test I make on road and if poor power it would meaning that time to regulator replace, cause all feul filters and sensors was changed...

What about hex dump structure? Someone can explain numbers before {C300} markers?

konq100
20th July, 2017, 12:53 PM
It's so simple, mate:

0191 - Code for defect memory (P0191)
0000 - CARB memorisation code bit 0
0000 - CARB memorisation code bit 1
0000 - CARB memorisation code bit 2
0000 - CARB memorisation code bit 3
0000 - CARB memorisation code bit 4
0000 - CARB memorisation code bit 5
0000 - CARB memorisation code bit 6
0000 - CARB memorisation code bit 7
0F10 - Ambient condition 1 for defect memory
0F00 - Ambient condition 2 for defect memory
1F6A - Ambient condition 3 for defect memory
0F7F - Ambient condition 4 for defect memory
1F5D - Ambient condition 5 for defect memory
0007 - FRPS priority + actuation of diagnostic lamp
C300 - Starting value for non-defect counter

WinWoj
20th July, 2017, 12:59 PM
Wow! This is from asap file or another ?