View Full Version : 2015- mazda cx5 carsh clered needed
cklair
14th August, 2017, 02:11 AM
hi I need to clear this file read by obd.
dragon100
14th August, 2017, 06:01 AM
Your cleared file, clear errors, switch ignition off for 10 sec, switch ignition on, clear errors again and done.
cklair
14th August, 2017, 05:04 PM
hi bud it worked 100%. thanks for your help
eprst
22nd August, 2017, 01:23 PM
Hi, I have the same car. I read the CPU and tried to remove the crash message. Set up the block in the car, removed the error, now I have DTC B1011:95. Please see dumps. Perhaps I that excess removed
Thanks
Regards
dragon100
22nd August, 2017, 01:26 PM
Post here your file to clear ...
eprst
22nd August, 2017, 01:27 PM
I added dumps
dragon100
22nd August, 2017, 01:32 PM
Number srs unit ?
dragon100
22nd August, 2017, 01:35 PM
Your cleared file, clear errors, switch ignition off for 10 sec, switch ignition on, clear errors again and done.
eprst
22nd August, 2017, 01:58 PM
pass please
eprst
25th August, 2017, 03:36 PM
Not working for me
dragon100
25th August, 2017, 07:01 PM
If srs unit Bosch, check Bosch driver on pcb, sometimes burn a little hole and need replace srs unit ...
eprst
27th August, 2017, 01:15 PM
Unit Autoliv
dragon100
27th August, 2017, 02:56 PM
My solution tested for this unit many times, I think so your srs unit not good ...
eprst
28th August, 2017, 06:18 PM
Maybe somebody have a solution?
carmelasse
13th September, 2017, 04:01 PM
Can I please to repair my file: Mazda CX-5 2014
Airbag module: KD35- 57K30-C
carmelasse
14th September, 2017, 06:35 PM
Any help please:)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.