View Full Version : 2011 Jetta 5K0 959 655B.
andrushka
12th September, 2017, 03:09 AM
Hi guys. I have a module from a flooded car that is dead. I also have a module from a used Jetta, that I want to use, but the problem is that coding and other stuff is wrong, so ABS light Is on etc. Is there a way to copy data from old dead module to new one or virginize that used module so dealer can program it...
Thanks for any help and suggestions.
Sent from my SM-G930V using Tapatalk
2hard
12th September, 2017, 03:55 AM
Try change/swap eeprom 95640 from older ecu to new one ;)
megabits
12th September, 2017, 04:08 AM
I believe this case is eeprom 95640.
Copy the eeprom 95640 data from the original module and paste it into the module you want to use.
megabits
12th September, 2017, 04:09 AM
Oops .... I arrived late ... Sorry ...
andrushka
13th September, 2017, 01:45 AM
I have tried to do that , but no luck. There is a TMS 470 processor inside, so I assume that all of the configuration is in that processor. I was hoping that somebody had done this before me and would have a diagram or connection points to that processor
Sent from my SM-G930V using Tapatalk
andrushka
13th September, 2017, 02:19 AM
Here is a pic of the board, Don't mind the missing eeprom...https://uploads.tapatalk-cdn.com/20170913/35a6009774143237f42f00f9103dd353.jpg
Sent from my SM-G930V using Tapatalk
2hard
13th September, 2017, 04:21 AM
I think data is in 95640.
See if helps:
http://www.digital-kaos.co.uk/forums/showthread.php/315872-Golf-6-5k0-959-655b-vw10-with-95640
http://www.digital-kaos.co.uk/forums/showthread.php/279965-2012-Jetta-5K0-959-655-B
473395
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.