View Full Version : I need to clone a CRD2.10 in a mb help pls.
honingkoning
17th September, 2017, 10:07 PM
Guys i need to clone a crd2.10 in a MB w212.
can i read eep without lifting pcb from ecu casing?
I know smok claims to read eep in boot mode but i would like to do this without buying this option, as i dont expect to do this a lot.
i have kess/ktag/gall/bdm100 several eep programmers (upa/xprog)
wbr Adam
Mario3
17th September, 2017, 10:26 PM
you should be able to access eeprom data with Ktag mate
good luck
honingkoning
18th September, 2017, 10:49 AM
you should be able to access eeprom data with Ktag mate
good luck
Do i need to remove pcb from casing?
Wbr
Mario3
20th September, 2017, 05:23 PM
I dont think you have to, i will make one tomorrow morning and let you know..
Regards
Sent from my SM-N9208 using Tapatalk
icezero2010
21st September, 2017, 08:27 AM
Do i need to remove pcb from casing?
Wbr
yes only with opening :-)
i know thats really hard on this ecu but no other way
honingkoning
22nd September, 2017, 12:17 PM
I dont think you have to, i will make one tomorrow morning and let you know..
Regards
Sent from my SM-N9208 using Tapatalk
Did you finished your job, for what purpose did you opened ecu.
Like i said i need to clone ecu, will this be good by copieing eep content.
If thats enough i will buy smok license, always good to have for future.
Wbr Adam.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.