Help with tacho nec78 and dgp3

[m35i]

hi , i try recalibrate dash in Peugeot 307 years 2003 with DGP3 and adapter st59 but always give me this error ..... PINCHECK

474616

i use this pinout

474617

pin 2 y 11 need lift of Pcb and solder The wiring or Only solder in The pin ???

Thanks

[m35i]

someone that make this with dgp3 clone ??

[brend]

Yes 2-11 pin must lift.

[jomberykaso]

That pinout is not correct

[jomberykaso]

use this pinout:
474714

Good Luck!

[m35i]

but this pinout is for dgp3 ?? or any nec programmer ??? with this pinout need lift pins ???

[brend]

but this pinout is for dgp3 ?? or any nec programmer ??? with this pinout need lift pins ???

You tried read lift pin ???

[m35i]

yes i try but not read with pinout of dgp3

[Cllau]

Dgp3 Clone it `s not good on nec...

[brend]

yes i try but not read with pinout of dgp3

jomberykaso give to you good conection.My digimaster have to conection like jomberykaso sulution and my tool worked .Maybe your adapter just not work.:hmmmm2:

[jomberykaso]

but this pinout is for dgp3 ?? or any nec programmer ??? with this pinout need lift pins ???

for any nec programmer

[m35i]

not work i think that this adapter is very bad for this work